激光剥蚀-电感耦合等离子体质谱准确测定锆石中钛的含量

肖志斌; 柳小明; 李正辉; 张红

激光剥蚀-电感耦合等离子体质谱准确测定锆石中钛的含量

1.
西北大学大陆动力学国家重点实验室, 陕西西安 710069
2.
西北大学大陆动力学国家重点实验室, 陕西西安 710069
3.
西北大学大陆动力学国家重点实验室, 陕西西安 710069
4.
西北大学大陆动力学国家重点实验室, 陕西西安 710069

计量
- 文章访问数: 1819
- HTML全文浏览量: 18
- PDF下载量: 1599
出版历程
- 收稿日期: 2011-11-24

Accurate Determination of Ti in Zircon by Laser Ablation-Inductively Coupled Plasma-Mass Spectrometry

1.
State Key Laboratory of Continental Dynamics, Northwest University, Xi'an 710069, China
2.
State Key Laboratory of Continental Dynamics, Northwest University, Xi'an 710069, China
3.
State Key Laboratory of Continental Dynamics, Northwest University, Xi'an 710069, China
4.
State Key Laboratory of Continental Dynamics, Northwest University, Xi'an 710069, China

摘要

摘要: 外标物质及内标元素的选择是激光剥蚀-电感耦合等离子体质谱(LA-ICP-MS)准确测定元素含量的关键因素之一。文章选用玻璃标准参考物质NIST 610、GSE-1G、BHVO-2G、BCR-2G、ATHO-G、KL2-G和T1-G作为外标,Si或Zr作为内标,对锆石M257中的Ti进行LA-ICP-MS微区原位测定。结果显示,选择Si或Zr作内标,采用BCR-2G、ATHO-G、KL2-G和T1-G作外标时,Ti含量测定值与参考值之间差异均较大,因此它们不适合作外标物质。采用BHVO-2G作外标和Si作内标,NIST 610作外标和Zr作内标,Ti含量测定值与参考值之间的差异均小于4%,因此BHVO-2G和NIST 610可有条件地作为外标物质。选择Si还是Zr作内标,GSE-1G作外标时,Ti含量的测定值与参考值之间的差异均小于3%,说明GSE-1G是较为合适的外标物质。选用GSE-1G作为外标,Si作内标,对5个标准锆石中的Ti含量进行了测定,结果显示,Ti元素在锆石91500中分布不均匀,而在锆石GJ-1、M257、PENGLAI和MUDTANK中分布均匀。在Ti元素分布均匀的GJ-1、M257、PENGLAI和MUDTANK等4个锆石中,由于Ti的含量均小于5 μg/g,不适合作为锆石中Ti元素测定用的外标物质,但可作为测定时的质量监控样品。
- 锆石Ti温度计 /
- 激光剥蚀-电感耦合等离子体质谱法 /
- NIST /
- 610 /
- GSE-1G /
- 外标物质
Abstract: The Ti content in zircon M257 was determined in-situ by LA-ICP-MS using Si and Zr as internal standards and NIST 610, GSE-1G, BHVO-2G, BCR-2G, ATHO-G, KL2-G and T1-G as external standards. The large difference between measured and referred values by using BCR-2G, ATHO-G, KL2-G and T1-G as external standards and Si or Zr as internal standard indicated that the four NIST standard materials were not suitable for external materials. Whether using Si as internal and BHVO-2G as external standards, or Zr as internal and NIST 610 as external standards, the difference between measured and referred values was less than 4%, which means that the two standard materials can be used as external standards selectively. Using GSE-1G as the external standard, whether Zr or Si is used as the internal standard, the difference between measured and referred values is less than 3%, which indicates that GSE-1G is a better external standard material. The Ti contents in 5 zircon standards were measured by using Si as internal and GSE-1G as external standards. The Ti distributions were heterogeneous in 91500 and homogeneous in GJ-1, M257, PENGLAI and MUDTANK. However, the Ti contents in the zircon standards of GJ-1, M257, PENGLAI and MUDTANK were less than 5 μg/g. Therefore all 5 zircon standards can not be used as external materials because of heterogeneity or lower Ti content, which can only be used as quality control materials in determination of Ti in zircons, except for 91500.
- Ti-in-zircon /
- thermometer /
- laser /
- ablation-inductively /
- coupled /
- plasma-mass

HTML全文

参考文献(11)

Trotzsch U, Ellis D J. High P-T study of solid solutions in the system ZrO₂-TiO₂: The stability of strilankite [J]. European Journal of Mineralogy, 2004, 16: 577-584.

Trotzsch U, Ellis D J. The ZrO₂-TiO₂ phase diagram [J]. Journal of Materials Science, 2005, 40: 4571-4577.

Watson E B, Harrison T M. Zircon thermometer reveals minimum melting conditions on earliest earth [J]. Science, 2005, 308: 841-844.

Watson E B, Wark D A, Thomas J B. Crystallization thermometers for zircon and rutile [J]. Contributions to Mineralogy and Petrology, 2006, 151: 413-433.

Ferry J M, Watson E B. New thermodynamic models and revised calibrations for the Ti-in-zircon and Zr-in-rutile thermometers [J]. Contributions to Mineralogy and Petrology, 2007, 154(4): 429-437.

Yuan H L, Gao S, Dai M N, Zong C L, Güther D, Fontaine G H, Liu X M, Diwu C R. Simultaneous determinations of U-Pb age, Hf isotopes and trace element compositions of zircon by excimer laser-ablation quadrupole and multiple-collector ICP-MS [J]. Chemical Geology, 2008, 247: 100-118.

Eggins S M, Shelley J M G. Compositional heterogeneity in NIST SRM 610-617 glasses [J]. Geostandards Newsletter, 2002, 11(2): 269-286.

Woodhead J D, Hergt J M. A preliminary appraisal of seven natural zircon reference materials for in situ Hf isotope determination [J]. Geostandards and Geoana-lytical Research, 2005, 29: 183-195.

Elhlou S, Belousova E, Griffin W L, Parson N J, O'Reilly S Y. Trace element and isotopic composition of GJ-red zircon standard by laser ablation [J]. Geochimica et Cosmochimica Acta, 2006, 70(18): A158.

Li X H, Long W G, Li Q L, Liu Y, Zheng Y F, Yang Y H, Chamberlain K R, Wan D F, Guo C H, Wang X C, Tao H. Penglai zircon megacrysts: A potential new working reference material for microbeam determination of Hf-O isotopes and U-Pb age [J]. Geostandards and Geoanalytical Research, 2010, 34: 117-134.

Nasdala L, Hofmeister W, Norberg N, Mattinson J M, Corfu F, Dorr W, Kamo S L, Kennedy A K, Kronz A, Reiners P W, Frei D, Kosler J, Wan Y S, Gotze J, Hager T, Kroner A, Alley J W. Zircon M257—A homogeneous natural reference material for the ion microprobe U-Pb analysis of zircon [J]. Geostandards and Geoanalytical Research, 2008, 32: 247-265.

施引文献

资源附件(0)

计量

文章访问数: 1819
HTML全文浏览量: 18
PDF下载量: 1599
被引次数: 0

激光剥蚀-电感耦合等离子体质谱准确测定锆石中钛的含量

计量

出版历程

Accurate Determination of Ti in Zircon by Laser Ablation-Inductively Coupled Plasma-Mass Spectrometry

计量

出版历程

目录